56
DE EN
4 Product description
4.1 Name plate and identication
Motor identication
UK
CA
XXXX-XX Cruise X.X
S.NR xxxxxxxxXxxxx-xx-x
input XX.X - XX.X V / max. XXX A
output XX.X kW
Manufactured 20XX by Torqeedo GmbH
Friedrichshafener Str. 4a, 82205 Gilching
Germany
3
1
2
1 Item number and motor type
2 Serial number
3 Nominal input voltage/max. input current/
nom. wave output power/weight
• Secure the boat to the landing stage or berth so that it cannot break free.
• There must always be one person on the boat at the time of calibration.
• Watch out for people in the water.
• Only use original Torqeedo cable sets.
• Power cables must not be extended and must not be laid in bundles.
• Find out about the intended travel area before you set off and observe the
forecast weather and sea conditions.
• Depending on the size of the boat, always have the necessary safety
equipment ready (anchor, paddle, means of communication, auxiliary drive
if necessary).
• Check the system for mechanical damage before starting to drive.
• Only drive with a system that is in perfect working order.
• Familiarise yourself with the travel area before setting off, as the range
shown in the onboard computer does not take into account wind, current
and direction of travel.
• Plan enough buffer for the required range.
• When operating with external batteries that do not communicate with the
data bus, carefully enter the connected battery capacity.
• Stay at a distance from the propeller.
• When working on the propeller, always switch off the system via the battery
main switch and remove the emergency stop magnetic chip.
• Observe the safety regulations.
• Do not lift the Cruise system alone and use suitable lifting gear.
• Do not connect other loads (e.g. sh nders, lights, radios, etc.) to the same
battery bank that powers the motors.
• While driving, make sure that there is no danger of the propeller touching
the ground.
• Always switch off the system via the main switch when working on batter-
ies.
• When connecting the batteries, make sure to connect the red positive cable
rst and then the black negative cable.
• When disconnecting the batteries, make sure to remove the black negative
cable rst and then the red positive cable.
• Never reverse the polarity.
• The emergency stop magnetic chip can erase magnetic data carriers.
• Keep the emergency stop magnetic chip away from magnetic data carriers.
To Next Page
Loading...
Need help?
General
