79
DE EN
Manual switch off
1. Set the accelerator lever to the neutral position.
» Hydrogeneration is ended.
» The “Charging” indicator in the display goes out.
8.4 Charging
The charging process of your Torqeedo system differs depending on the
conguration and components used.
The corresponding information can be found in the operating manual for the
respective charger unit.
NOTE! Only use Torqeedo charger units for Torqeedo batteries.
NOTE! To charge the batteries in the boat, a land connection in the boat with
galvanic isolator is required according to applicable national requirements (e.g.
DIN EN ISO 13297, ABYC E-11).
NOTE! Never use mains power cables coiled up to avoid overheating of the
cables.
8.4.1 Charging with Power 24 batteries
Charging
1. Switch on the batteries or the system.
2. Plug in the charger unit.
3. The charging process starts automatically.
4. “Charging” is shown in the display.
5. Fully charge the batteries.
Ending charging
1. Unplug the charger unit.
2. Switch off the system or the battery.
8.4.2 Charging with Power 48 batteries
Charging
1. Switch off the Torqeedo system.
2. Plug in the charger unit.
3. The charging process starts automatically.
4. “Charging” is shown in the display.
5. Fully charge the batteries.
Ending charging
1. Unplug the charger unit.
8.4.3 Charging with external batteries
Charging
1. Switch off the Torqeedo system.
2. Fully charge your battery bank according to your battery and charger unit
manufacturer's instructions.
Stopping charging (only Cruise models with tiller)
1. Unplug the charger unit.
2. Switch on the Torqeedo system.
3. Press the “cal” button 2x within 1 second to conrm that the state of charge
in the system is 100%.
End loading (Cruise models with remote accelerator lever)
1. Unplug the charger unit.
2. Switch on the Torqeedo system.
3. Conrm the charge level of 100 % in the system, see operating manual for
the remote accelerator lever.
To Next Page
Loading...
Need help?
General
