December 2005 © TOSHIBA TEC e-STUDIO163/203 SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
1 - 1
1
1. SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
1.1 Specifications
Copy process Indirect electrophotographic process (dry)
Type Desktop type
Original table Fixed type (the left rear corner used as guide to place originals)
Accepted originals Sheet, book and 3-dimensional object. The automatic document feeder
(ADF) only accepts paper which are not pasted or stapled. (Single-sided orig-
inals: 50 to 127 g/m
2
/13 to 34 lb. Bond) Carbon paper are not acceptable
either.
Maximum size: A3/LD
Copy speed (Copies/min.)
e-STUDIO163
e-STUDIO203
* “–” means “Not acceptable”.
* The copy speed in the above table are available when originals are manually placed for single side,
multiple copying.
* When the ADF is used, the copy speed of 16[20] sheets per minute is only available under the fol-
lowing conditions:
• Original/Mode: Single side original/A4/LT size. APS/automatic density are not selected.
• Number of sheets: 16[20] or more.
• Reproduction ratio: 100%
Values in [ ] are for e- STUDIO203 in case that the specification is different among e-STUDIO163
and e-STUDIO203.
Paper size Drawer
Bypass feed
PFU
Size specified Size not specified
A4, B5, LT 16 16 11 16
A5-R, ST-R - 16 11 -
A4-R, B5-R, LT-R 15.5 15.5 11 15.5
B4, LG, FOLIO, COMPUTER 13 13 11 13
A3, LD 11 11 11 11
Paper size Drawer
Bypass feed
PFU
Size specified Size not specified
A4, B5, LT 20 20 11 20
A5-R, ST-R - 20 11 -
A4-R, B5-R, LT-R 15.5 15.5 11 15.5
B4, LG, FOLIO, COMPUTER 13 13 11 13
A3, LD 11 11 11 11
To Next Page
Loading...
Need help?
General
