e-STUDIO163/203 ERROR CODE AND SELF-DIAGNOSTIC MODE December 2005 © TOSHIBA TEC
2 - 4
<Operation procedure>
• Input check mode (03): Refer to " P. 2-5 "2.2.1 Input check (Test mode 03)".
• Output check mode (04): Refer to " P. 2-8 "2.2.2 Output check (Test mode 04)".
• Test print mode (07): Refer to " P. 2-10 "2.2.3 Test print mode (Test mode 07)".
• Adjustment mode (05): Refer to " P. 2-16 "2.2.7 Adjustment mode (05)".
• Setting mode (08): Refer to " P. 2-32 "2.2.8 Setting mode (08)".
• List print mode (9S):Refer to " P. 2-11 "2.2.4 List Print Mode (9S)"
• Access code mode (8S): " P. 2-13 "2.2.5 Access code mode (8S)"
• Function setting mode (1*): " P. 2-15 "2.2.6 Function Setting Mode (1*)"
<Number display>
The numbers are displayed on a 7-segment LED.
A number of more than 3 digits long is separated as follows, and is displayed from the high-order posi-
tion. Press the reproduction ratio button ([200%] or [25%]) to shift the display to the 3 digits of the next
lower/higher order.
E.g.1) Displaying 1,000,000
Fig. 2-2
E.g. 2) Displaying 80,000
Fig. 2-3
To Next Page
Loading...
