e-STUDIO163/203 ADJUSTMENT December 2005 © TOSHIBA TEC
3 - 12
(8) If not, use the following procedure to change values and repeat the steps (3) to (7) above.
(Adjustment Mode) # (Key in the code [405]) # [START]
# (Key in a value (acceptable values: 0 to 255))
# Press the [INTERRUPT] button (stored in memory).# (“AJ” is displayed.)
* The larger the adjustment value is, the higher the reproduction ratio and the longer the dis-
tance A become (approx. 0.125 mm/step).
Fig. 3-8
50 100 150 200 250
A
Feeding direction
Copied image of the ruler
To Next Page
Loading...
