Toshiba e-studio205L - Density Adjustment

3
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ADJUSTMENT
3 - 23
3.4.2 Density adjustment
The center density and the density variation controlled by density adjustment keys can be adjusted as
follows.
< Adjustment Mode (05) >
Make a test copy and compare the image obtained with the current settings; if necessary, make
adjustment using the following procedure.
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in a code and press the [START] button.
(3) Key in an adjustment value.
(To correct the keyed-in value, press the [CLEAR] button.)
(4) Press the [ENTER] or [INTERRUPT] button to store the value.  The equipment goes back to
the ready state.
(5) Press the [FAX] button and then the [START] button. Then perform test copying.
(6) If the desired image density has not been attained, repeat step (2) to (5).
Original mode
Item to be adjusted Remarks
Text/
Photo
Photo Text
User
Custom
503 501 504 931 Manual density mode
center value
The larger the value is, the darker the
image becomes.
Acceptable values: 0 to 255
(Default: 128)
505 506 507 934 Manual density mode light
step value
The larger the value is, the lighter the
light side becomes.
Acceptable values: 0 to 255
(Default: 20)
508 509 510 937 Manual density mode dark
step value
The larger the value is, the darker the
dark side becomes.
Acceptable values: 0 to 255
(Default: 20)
514 512 515 940 Automatic density mode The larger the value is, the darker the
image becomes.
Acceptable values: 0 to 255
(Default: 128)