Toshiba e-studio205L - Fine Adjustment of Black Density

e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 36
3.6.7 Fine adjustment of black density
The density of black side on scanned image is adjusted at color-scanning.
<Adjustment Mode (05)>
Note:
Be careful for the value not to be too large since the gradation is reproduced worse in darker
side.
<Procedure>
The procedure is the same as that of  P.3-32 "3.6.2 Density adjustment".
3.6.8 RGB conversion method selection
The color space conversion method of image is decided at color-scanning.
<Adjustment Mode (05)>
<Procedure>
The procedure is the same as that of  P.3-32 "3.6.2 Density adjustment".
3.6.9 Adjustment of saturation
The saturation of the scanned image is adjusted for color-scanning.
<Adjustment Mode (05)>
<Procedure>
The procedure is the same as that of  P.3-32 "3.6.2 Density adjustment".
Code Original mode Remarks
1075 Text The larger the value is, the black side of the image becomes darker.
Acceptable values: 0 to 4 (Default: 0)
1076 Printed Image
1077 Photo
8371 User custom
Code Original mode Remarks
1080 Text 0: sRGB, 1: AppleRGB, 2: ROMMRGB, 3: AdobeRGB
(Default: 0)
1081 Printed Image
1082 Photo
8372 User custom
Code Original mode Remarks
8325 Text The larger the value is, the brighter the image becomes.
The smaller the value is, the duller the image becomes.
Acceptable values: 0 to 255 (Default: 128)
8326 Printed Image
8327 Photo
8373 User custom