Toshiba e-studio205L - Adjustment of the Paper Feeding System

3
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ADJUSTMENT
3 - 55
3.10 Adjustment of the Paper Feeding System
Adjust the laser writing start position in the primary scanning direction with the lower drawer. (05-410,
05-411)
If deviation still occurs, perform the following:
3.10.1 Sheet sideways deviation caused by paper feeding
<Procedure>
Bypass feeding
The center of the printed image shifts to the front
side.  Move the guide to the front side (Arrow
(A) direction in the lower figure).
The center of the printed image shifts to the rear
side.  Move the guide to the rear side (Arrow
(B) direction in the lower figure).
Fig. 3-41
Fig. 3-42
(1) Loosen the screw.
(2) Move the entire guide to the front or rear
side.
(3) Tighten the screw.
Fig. 3-43
Feeding direction
Center
[Rear]
[Front]
Feeding direction
Center
[Rear]
[Front]
(A)
(B)