e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
PREVENTIVE MAINTENANCE (PM)
5 - 26
5.7.6 Fuser unit
Fig. 5-15
* a. Fuser roller
When replacing the fuser roller, apply small amount of grease on the inside of fuser roller
bearings.
Items to check Cleaning Lubrication
Replacement
(x 1,000 sheets)
Operation
check
Parts list
<P-I>
a Fuser roller W2 240/200/240/250/
300
31-15
b Pressure roller 240/200/240/250/
300
32-8
c Separation finger for
fuser roller
80/100/120/125/
150
31-22
d Fuser unit entrance guide A 32-11
e Thermistor (3 pcs.) A R 31-12
31-13
f Drive gear (tooth face
and shaft)
W2 R 31-11
g Fuser roller gear R 31-18
c
a, g
e
b
d
f
To Next Page
Loading...
