e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSIS MODES
2 - 4
2.2 Input Check (Test Mode 03)
The status of each input signal can be checked by pressing the [FAX] button, and the digital keys in the
test mode (03).
Operation procedure
Note:
Initialization is performed before the equipment enters the test mode.
Fig. 2-2 Example of display during input check
Items to be checked and the condition of the equipment when the buttons [A] to [H] are highlighted are
listed in the following pages.
[0][3]
[POWER]
[START] [FAX] [Digital keys]
[CLEAR]
(LCD ON)
[POWER] OFF/ON
(Exit)
or
[COPY]
To Next Page
Loading...
