3
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ADJUSTMENT
3 - 49
[B] Adjusting carriages-1 and -2 positions
<Procedure>
(1) Move the carriage-2 toward the exit side.
(2) Loosen the screws fixing the front side pulley bracket, make the sections A and B of the carriage-
2 touch with the inside of the exit side frame and screw them up.
Fig. 3-32
(3) Put the carriage-1 on the rail, make the sections C and D of it touch with the inside of the exit
side frame and screw up the front/rear sides of the bracket to fix it.
Note:
Make sure that the sections A and B of the carriage-2 touch with the exit side frame.
Fig. 3-33
A
B
Carriage-2
Pulley bracket
[Rear]
[Front]
Exit side frame
Carriage-1
[Rear]
[Front]
Exit side frame
Bracket
Bracket
To Next Page
Loading...
