Toshiba e-studio205L - Page 303

3
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ADJUSTMENT
3 - 63
(4) Position the pins with the holes on the RADF
by moving it so that the pins fit into the holes
when the RADF is closed.
Fig. 3-62
(5) Tighten the left-hand hinge screw at the rear
side.
Fig. 3-63
(6) Loosen the hole position adjustment screws
on the right hand side.
Fig. 3-64