e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 70
Duplex copying:
(1) Shift the aligning plate with the scale as the guide shown in the figure below to adjust the skew.
Fig. 3-76
(2) If the image skew is "C" as shown in the figure below, shift the aligning plate in the direction of "-
", and if "D", shift it to "+".
Fig. 3-77 Fig. 3-78
Shift the aligning plate in the direction of "-". Shift the aligning plate in the direction of "+".
C
D
To Next Page
Loading...
