Toshiba e-studio205L - Page 345

4
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
BACKUP FUNCTION
4 - 9
* No items are selected in the screen by default.
* Be sure to restore the same option items in the same condition as when the option items were
backed up.
<When “6: SRAM Data Restore” is selected>
(5) Press the [START] button. The restore starts and the restoring status is displayed on the LCD
screen.
(6) “Restore Completed” is displayed on the LCD screen when restoring has been properly
completed.
(7) Turn the power OFF and remove the USB media.
* When “department management data” or “user management data” are restored, clear their counter
values in a procedure below.
(8) Counter values can be all cleared as the data are copied. Note that the total counter values are
not copied.
<Procedure>
Press the buttons as follows: [COUNTER][DEPARTMANT MANAGEMENT]Enter the
password[RESET ALL COUNTERS]
* Enable the department management when the [RESET ALL COUNTERS] buttons is set to be
disabled.
Fig. 4-10
Number Restore Item
1. SRAM Restoring SRAM Data
* No items are selected in the screen by default.
Fig. 4-11