6
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ERROR CODE AND TROUBLESHOOTING
6 - 7
EA80 Finisher jam
(Saddle Stitcher
section)
Stapling jam: Stapling is not performed properly.
[MJ-1024]
P. 6 - 59
EA90 Door open jam: The delivery cover or inlet cover
has opened during printing [MJ-1024/MJ-1101].
P. 6 - 59
EAA0 Power-ON jam: Paper exists at No.1 paper sensor,
No. 2 paper sensor, No.3 paper sensor, vertical
path paper sensor or delivery sensor when power is
turned ON. [MJ-1024/MJ-1101]
P. 6 - 59
EAB0 Saddle paper transport stop jam: The paper which
passed through the inlet sensor does not reach or
pass through the folding position sensor. [MJ-1025]
P. 6 - 60
EAC0 Saddle transport delay jam: The paper which has
reached the inlet sensor does not pass through this
sensor. [MJ-1025/MJ-1024]
P. 6 - 61
EAD0 Other paper jam Print end command time-out jam: The printing has
not finished normally because of the
communication error between the SYS board and
LGC board at the end of printing.
P. 6 - 62
EAE0 Finisher jam Receiving time time-out jam: The printing has been
interrupted because of the communication error
between the equipment and finisher when the
paper is transported from the equipment to the
finisher.
P. 6 - 62
EB30 Ready time time-out jam: The equipment judges
that the paper transport to the finisher is disabled
because of the communication error between the
equipment and finisher at the start of printing.
P. 6 - 62
EB50 Paper transport jam Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper.
P. 6 - 36
EB60 Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper (redetection after no jam is
detected at [EB50]).
P. 6 - 37
ED10 Finisher jam Skew adjustment motor home position detection
abnormality: The Skew adjustment motor is not at
the home position. [MJ-1101 (when MJ-6101 is
installed)]
P. 6 - 62
ED11 Sideways adjustment motor home position
detection error: The Sideways adjustment motor is
not at the home position. [MJ-1101 (when MJ-6101
is installed)]
P. 6 - 62
ED12 Shutter home position error: The shutter is not at
the home position. [MJ-1101]
P. 6 - 63
ED13 Front alignment plate home position error: The front
alignment plate is not at the home position. [MJ-
1101]
P. 6 - 63
ED14 Rear alignment plate home position error: The rear
alignment plate is not at the home position. [MJ-
1101]
P. 6 - 63
ED15 Paddle home position error: The paddle is not at the
home position. [MJ-1101]
P. 6 - 63
ED16 Buffer tray home position error: The buffer tray is
not at the home position. [MJ-1101]
P. 6 - 63
Error code Classification Contents Troubleshooting
To Next Page
Loading...
