Toshiba e-studio205L - Page 438

e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 34
Relation between the jamming area and the corresponding sensors/covers
(If a jam is occurring in the ADU, LCF, PFP, JSP or OCT check the board in each unit.)
[E570] Jam not reaching the reverse sensor
[E580] Stop jam at the reverse sensor
1. Open the ADU and remove paper if there is any on the transport path.
* If the error still occurs, check the following:
2. IIs the reverse sensor working? (Perform the input check in the test mode: 03-[FAX]ON/[9]/[C])
* If it is working normally, go to step 6. If it is not, check 3 to 5.
3. Check if the connector pins are disconnected or the harnesses are open circuited between the
reverse sensor and the connector CN304 on the LGC board. Correct if there is any abnormality.
4. Replace the reverse sensor.
5. Replace the LGC board.
6. Is the reverse motor working? (Perform the output check in the test mode: 03-123/173)
* If it is working normally, go to step 11. If it is not, check 7 to 10.
7. Check if the connector pins are disconnected or the harnesses are open circuited between the
reverse motor and the connector CN304 on the LGC board (and also the connectors CN401 and
CN406 on the MOT2 board). Correct if there is any abnormality.
8. Replace the reverse motor.
9. Replace the MOT2 board.
10.Replace the LGC board.
11.Check the exit roller. Replace it if it is worn out.
Jamming area Cover Sensor Test mode/Input check
Registration area Automatic duplexing
unit
Registration sensor 03-[FAX]ON/[9]/[A]
1st transport sensor 03-[FAX]OFF/[6]/[A]
Exit area Automatic duplexing
unit
Exit sensor 03-[FAX]ON/[9]/[B]
ADU ADU ADU entrance sensor 03-[FAX]OFF/[1]/[D]
ADU exit sensor 03-[FAX]OFF/[1]/[E]
Feeding area
(Main unit)
Feed cover 2nd transport sensor 03-[FAX]OFF/[7]/[A]
LCF LCF side cover LCF feed sensor 03-[FAX]OFF/[4]/[C]
PFP PFP side cover PFP upper drawer feed sensor 03-[FAX]OFF/[2]/[B]
PFP lower drawer feed sensor 03-[FAX]OFF/[3]/[B]
Bridge unit Bridge unit Bridge unit transport sensor-1 03-[FAX]ON/[4]/[G]
03-[FAX]ON/[3]/[G]
Bridge unit transport sensor-2 03-[FAX]ON/[4]/[F]
03-[FAX]ON/[3]/[G]
JSP JSP cover JSP feed sensor 03-[FAX]ON/[3]/[G]
OCT OCT cover OCT feed sensor 03-[FAX]ON/[3]/[G]
Finisher Finisher door Sensors in the finisher -