Toshiba e-studio205L - Page 474

e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 70
[C280] Do the carriages make a big noise after they arrive at the home position?
l
l
l

YES  The carriage home position sensor is not turned ON.
1. Check if the connector of the sensor is disconnected.
2. Replace the carriage home position sensor.
3. Replace the SLG board.
NO
The carriages are stopped at the home position and do not move.
1. Check if the connector pins are disconnected and the harnesses are short circuited or
open circuited.
2. Check if the conductor pattern on the SLG board is short circuited or open circuited.
3. Replace the SLG board.