Toshiba e-studio205L - Page 556

e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMANT OF HDD/PC BOARDS
7 - 10
2. CN115
[A] Replace DIMM and SRAM boards
Note:
Before replacing the SYS board, perform the following procedure.
 P.7-1 "7.1.1 Precautions when replacing PC boards"
(1) Confirm that the main power switch is turned OFF.
(2) Replace the SYS board.
(3) Install DIMM (main memory) to the new SYS board (from the old SYS board).
(4) Install SRAM board to the new SYS board (from the old SYS board).
[B] Update system ROM version
Update the version of system ROMs (OS data, UI data, System Firmware) with the USB media.
 P.8-5 "8.1 Firmware Updating with USB Media"
[C] Check ROM versions
Turn ON the main power switch and perform the following codes.
• System firmware ROM version (08-900)
• FROM basic section software version (08-920)
• FROM Internal program (08-921)
• Version of UI data in FROM displayed at power-ON (08-930)
[D] Reinstall options
When any of the options below was installed, reinstall a license for the corresponding option following
its unpacking instructions.
• Meta Scan Enabler (GS-1010)
• External Interface Enabler (GS-1020)
• Data Overwrite Enabler (GP-1070)
• IPSec Enabler (GP-1080)
123