Toshiba e-studio205L - Page 560

e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMANT OF HDD/PC BOARDS
7 - 14
[E] Enable HDD encryption
If the HDD encryption function has been set, perform the following procedure.
(1) Start up with the Setting mode (08).
(2) Enable the HDD encryption function (08-9379).
(3) Format the HDD (08-690).
(4) Turn the power OFF.
[F] Adjust image quality
(1) Start up with the Adjustment mode (05).
(2) Perform “Data transfer of characteristic value of scanner” (05-364).
(3) Perform “Automatic gamma adjustment” <PPC> (05-580).
 P.3-22 "3.4.1 Automatic gamma adjustment"
(4) Turn the power OFF.
[G] Initialize settings when FAX Unit (GD-1250) is installed
(1) Install the FAX Unit (GD-1250).
(2) Start up with the Setting mode (08).
(3) Set the destination of FAX (08-701).
(4) Turn the power OFF.
(5) Start up with the FAX Clearing Mode (1*).
(6) Perform the FAX Set Up (1*-100).
(7) Turn the power OFF and then back ON.
(8) Set the dial type according to these buttons: [USER FUNCTIONS] -> [ADMIN] -> [FAX] ->
[INITIAL SETUP]
[H] Set date and time
Set the date and time according to these buttons.
[USER FUNCTIONS] → [ADMIN] → [GENERAL] → [CLOCK] → [DATE/TIME]
[I] Reinstall options
When any of the options below was installed, reinstall a license for the corresponding option following
its unpacking instructions.
• Meta Scan Enabler (GS-1010)
• External Interface Enabler (GS-1020)
• Data Overwrite Enabler (GP-1070)
• IPSec Enabler (GP-1080)