Toshiba e-STUDIO2303A - Page 132

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 12
4.2.4 USB cable <20L/23L/25L/20H/23H/25H>
(3) Disconnect 2 connectors and release 2
latches. Take off the LED panel [2].
Fig. 4-30
(1) Take off the control panel unit.
 P. 4-10 "4.2.1 Control panel unit"
(2) Take off the original glass.
 P. 4-15 "4.3.1 Original glass"
(3) Release the 2 clamps [1] and then remove
the USB cable [3] from the main board [2].
Fig. 4-31
(4) Remove 4 screws, lift the scanner unit [4] a
little and then remove the USB cable [5].
Fig. 4-32
[2]
[3]
[1]
[2]
[4]
[5]