Toshiba e-STUDIO2303A - Center Heater Lamp (LAMP1)

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 80
4.8.3 Center heater lamp (LAMP1)
(1) Take off the fuser unit cover/fuser unit guide
 P. 4-78 "4.8.2 Fuser unit cover/Fuser unit
guide"
(2) Disconnect 2 Faston terminals [1].
Fig. 4-211
Notes:
Do not remove the Faston terminal by force,
but pull it out while pressing its lock.
Fig. 4-212
(3) Remove 2 screws.
Front side: M3x5
Rear side: M3x8
Fig. 4-213
M3x5
M3x8
[1]
[1]
M3x8
M3x5