Toshiba e-STUDIO2303A - Laser Optical Unit

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 28
4.4 Laser Optical Unit
4.4.1 Laser optical unit
(1) Take off the inner tray.
 P. 4-2 "4.1.3 Inner tray"
(2) Remove the ADU fan duct unit.
 P. 4-126 "4.11.6 ADU fan duct unit"
Notes:
Only when having equipped with ADU.
(3) Disconnect 2 connectors [1].
Notes:
1. Connect the flat harness to the LDRS
board with its electrode side inside the
equipment.
2. Pull out the connector for the polygonal
motor slantwise to the front side of the
equipment. Be careful, if you forcefully
pull it out to the rear side of the
equipment, you may break it.
Fig. 4-70
Fig. 4-71
(4) Remove 2 screws and raise the laser optical
unit [2] to take it off.
Fig. 4-72
[1]
[1]
[2]