e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 4
6.3 Image Dimensional Adjustment
6.3.1 General description
There are several adjustment items in the image dimensional adjustment, as listed below. When
adjusting these items, the following adjustment order should strictly be observed.
Item to be adjusted
Code in mode 05
20L/23L/25L,
23LA/23LM/
28LM
20H/23H/25H,
23HA/28HA
1 Light volume adjustment of scanner LED 3219 3219
2 Paper alignment at the registration roller 4100, 4101,
4102, 4103,
4104, 4105,
4107, 4110,
4120, 4405
4100, 4101,
4102, 4103,
4104, 4105,
4107, 4108,
4109, 4110,
4120, 4405
3 Printer related
adjustment
(a) Reproduction ratio of primary scanning direction
(Fine adjustment of image writing frequency/
PRT)
4001 4001
(b) Primary scanning data laser writing start position
Drawer sideways deviation
4006
4018
4006
4018
(c) Reproduction ratio of secondary scanning
direction
(Fine adjustment of main motor rotation speed)
4009 4009
(d) Secondary scanning data laser writing start
position
4058, 4059,
4061, 4062
4058, 4059,
4060, 4061,
4062
(e) Primary scanning data laser writing start position
at duplexing
4019 4019
4 Scanner related
adjustment
(a) Reproduction ratio of primary scanning direction 4000 4000
(b) Image location of primary scanning direction 3030 3030
(c) Reproduction ratio of secondary scanning
direction
3032 3032
(d) Image location of secondary scanning direction 3031 3031
(e) Top margin 4050 4050
(f) Left margin 4051 4051
(g) Right margin 4052 4052
(h) Bottom margin 4053 4053
To Next Page
Loading...
