Toshiba e-STUDIO2303A - Fuser Unit Cover;Fuser Unit Guide

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 78
4.8.2 Fuser unit cover/Fuser unit guide
3. When installing the fuser unit, hold the
positions shown in the figure.
Fig. 4-204
(1) Take off the fuser unit.
 P. 4-77 "4.8.1 Fuser unit"
(2) Place the fuser unit upside down.
Remove 1 screw and release the latch, take
off the bias plate [1].
Fig. 4-205
(3) Remove 2 screws and then take off entrance
guide [2].
Notes:
1. When removing the entrance guide, be
careful not to scratch the fuser roller and
pressure roller with the entrance guide
edge.
Fig. 4-206
[1]
[2]