Toshiba e-STUDIO2303A - Bypass Feed Roller <23 LA;23 LM;28 LM;23 HA;28 HA>

4
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
4 - 37
4.6.6 Bypass feed roller <23LA/23LM/28LM/23HA/28HA>
(5) Remove 1 bushing [3], and then take off the
bypass feed roller [4].
Fig. 4-93
Notes:
When attaching the bypass feed roller, align
the shaft pin [5] with the groove on the feed
roller and then clip it on with the clip.
Fig. 4-94
(1) Open the bypass feed roller [1].
Fig. 4-95
[3]
[4]
[5]
[1]