Toshiba e-STUDIO2303A - Lamps and Heaters

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
3 - 16
3.3.5 Lamps and heaters
3.3.6 Thermistors and thermostats
Symbol Name Function Remarks P-I
LAMP1 HTR-LAMP
Center Heater lamp
Heating the center section of the fuser
roller.
Fig. 3-11
Fig. 3-12
17-22
LAMP2 SIDE-LAMP
Side heater lamp
Heating the section of both sides of
fuser roller
Fig. 3-11
Fig. 3-12
17-33
ERS LP-ERS
Discharge LED
Removing the residual charge from the
drum surface
Fig. 3-13
Fig. 3-14
13-2
DH1 DRM-DH
Drum damp heater
Preventing condensation of the drum
* Optional for NAD/MJD/CND model,
standard for other models
Fig. 3-13
Fig. 3-14
6-11
Symbol Name Function Remarks P-I
THMS1 THMS-C-HTR
Center thermistor
Detecting the surface temperature at the
center of the fuser roller (for controlling
the center heater lamp)
Fig. 3-11 17-23
Fig. 3-12
THMS2 THMS-S-HTR
Side thermistor
Detecting the surface temperature at the
rear side of the fuser roller (for
controlling the temperature of the side
heater lamp)
Fig. 3-11 17-23
Fig. 3-12
THMS3 THMS-EDG-HTR
Edge thermistor
Detecting the surface temperature at the
edge of the rear side of the fuser roller
(for preventing overheating)
<20L/23L/25L/20H/23H/25H>
Fig. 3-11 17-23
Detecting the surface temperature at the
edge of the front side of the fuser roller
(for preventing overheating)
<23LA/23LM/28LM/23HA/28HA>
Fig. 3-12
THMS4 THMS-DRM
Drum thermistor
Detecting the temperature on the drum
surface
Fig. 3-13
Fig. 3-14
5-30
THMO1 THRMO-FSR-C
Fuser center thermostat
Preventing overheating in the fuser unit Fig. 3-11
Fig. 3-12
17-6
THMO2 THRMO-FSR-F
Fuser front thermostat
Preventing overheating in the fuser unit Fig. 3-11
Fig. 3-12
17-35
THMO3 THRMST-CS-L
Drum damp heater thermostat
Preventing overheating in the drum
damp heater
Fig. 3-13
Fig. 3-14
6-17