Toshiba e-STUDIO2303A - Image Dislocation in Feeding Direction

8
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
ERROR CODE AND TROUBLESHOOTING
8 - 85
8.4.18 Image dislocation in feeding direction
Fig.8-20
Defective area Step Check items Prescription
Scanner/Printer
adjustment
1 Have the printed images been
dislocated in the same manner?
Adjust the position of the leading
edge of paper in the Adjustment
Mode.
Registration roller 2 Is the registration roller dirty, or the
spring detached?
Clean the registration roller with
alcohol.
Securely attach the springs.
3 Is the registration roller working
properly?
Adjust or replace the gears if they are
not engaged properly.
Feed clutch 4 Is the feed clutch working properly? Check the circuit or feed clutch, and
replace them if necessary.
Pre-registration guide 5 Is the pre-registration guide installed
properly?
Install the guide properly.
Feeding direction