4
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
DISASSEMBLY AND REPLACEMENT
4 - 89
Notes:
1. When installing the thermistors, do not
mix up the installation positions of the
center thermistor, the side thermistor and
the edge thermistor by telling them apart
by the length of their harnesses.
2. The thermistors have different front and
back sides. When installing them, face
the shiny side inside and insert the boss
into the attaching fixture and install them.
Notes:
Check if the thermistors are deformed. If so,
do not use them.
Notes:
Make sure that the installation direction of
the thermistors is correct.
Fig. 4-236
Fig. 4-237
Fig. 4-238
Center thermistor
Edge thermistor
Side thermistor
To Next Page
Loading...
