Toshiba e-STUDIO2303A - Page 345

7
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
PREVENTIVE MAINTENANCE (PM)
7 - 3
<23LA/23LM/28LM/23HA/28HA>
Fig. 7-2
[CANCEL] pressed
[ ] pressed
[2]
[START]
[1] [START]
Adjustment
finished
Main unit chosen
[ ] pressed
Sub unit chosen
[ ] pressed
PMSUPPORTMODE
NOTINSTALLEDDEV
INSTALLEDDEV
INSTALLEDDEV
NOTINSTALLEDDEV
PMSUPPORTMODEPMSUPPORTMODE
NOTINSTALLEDDEV
INSTALLEDDEV
PMSUPPORTMODE
OPENFRONTCOVER
SETDEV.CARTRIDGE
CLOSEFRONTCOVER
PM support mode activated
[6] + [START] + [POWER] ON
Main Unit screen
Main unit list displayed
Sub Unit screen
Sub unit list displayed
Item chosen
[ ] pressed
Counter Item screen
Counter item
displayed.
Counter value screen
Counter value
displayed.
Code input screen
Code input screen
displayed.
Auto-toner automatic
adjustment perfomed
Automatic gamma
adjustment perfomed
[ ] pressed
[ ] pressed
Adjustment
finished
PM support mode:
Select screen for the developer material type
When a cartridge type
developer material is used,
select "INSTALLED DEV"
as shown below.
When a pouch type developer
material is used (the material
has already been installed in
the developer unit), select
"NOT INSTALLED DEV"
as shown below.