Toshiba e-STUDIO2303A - Page 408

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 30
[E150] PFP upper drawer misfeeding (paper not reaching the PFP upper drawer feed sensor)
Classification Error content
Paper misfeeding Jam not reaching the PFP upper drawer feed sensor
Proce
dure
Check item Result Measure
Next
Step
1
Open the PFP side cover.
Is there any paper in front
of the PFP upper drawer
feed sensor?
Yes Remove the paper.
No
2
2
Is the PFP upper drawer
feed sensor working?
(Perform the input check
in the test mode: 03-[1]/
[E])
Yes
3
No • Check if the connector of the PFP upper
drawer feed sensor is disconnected.
• Check if either of the connectors CN410 on
the PFP board is disconnected.
• Check if any of the connectors on the MAIN
board is disconnected.
20L/23L/25L/20H/23H/25H: CN26
23LA/23LM/28LM/23HA/28HA: CN15
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the PFP
board and MAIN board are short circuited or
open circuited.
• Replace the PFP upper drawer feed sensor.
• Replace the PFP board.
• Replace the MAIN board.
3
Is the PFP upper drawer
feed clutch working?
(Perform the output check
in the test mode: 03-227)
Yes
4
No • Check if the connector of the PFP upper
drawer feed clutch is disconnected.
• Check if any of the connectors CN410 on
the PFP board is disconnected.
• Check if any of the connectors on the MAIN
board is disconnected.
20L/23L/25L/20H/23H/25H: CN26
23LA/23LM/28LM/23HA/28HA: CN15
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the PFP
board and MAIN board are short circuited or
open circuited.
• Replace the PFP upper drawer feed clutch.
• Replace the PFP board.
• Replace the MAIN board.
4
PFP upper drawer feed
roller
Separation roller
Pickup roller
• Check the PFP upper drawer feed roller,
separation roller and pickup roller.
Replace them if they are worn out.
Parts to be replaced Remark
PFP upper drawer feed sensor
PFP board