Toshiba HX7+ ASD - Page 124

HX7+ ASD Installation and Operation Manual 115
BIN Speed Frequency #1
Program Frequency Setting  Speed Reference Setpoints BIN
This parameter is used to set the gain and bias of the binary input when the
discrete input terminals are used as the control input while operating in the
Speed Control mode.
This parameter sets BIN Speed Frequency #1 and is the frequency that is
associated with the setting of BIN Speed Reference #1 while operating in the
Speed Control mode.
See BIN Speed Reference #1 (F228) for further information on this setting.
Direct Access Number — F229
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Ye s
Minimum — -Max. Freq. (F011)
Maximum — Max. Freq. (F011)
Units — Hz
BIN Speed Reference #2
Program Frequency Setting  Speed Reference Setpoints BIN
This parameter is used to set the gain and bias of the binary input when the
discrete input terminals are used as the control input while operating in the
Speed Control mode or the Torque Control mode.
See BIN Speed Reference #1 for further information on this setting when used
for Speed control or Torque control.
This parameter sets BIN Speed Reference #2 and is the input signal that is
associated with the setting of BIN Speed Frequency #1 while operating in the
Speed Control mode or is associated with the BIN Torque Reference Setpoint
#2 while operating in the Torque control mode.
Direct Access Number — F230
Parameter Type — Numerical
Factory Default — 100.00
Changeable During Run — Ye s
Minimum — 0.0
Maximum — 100.0
Units — %
BIN Speed Frequency #2
Program Frequency Setting  Speed Reference Setpoints BIN
This parameter is used to set the gain and bias of the binary input when the
discrete input terminals are used as the control input while operating in the
Speed Control mode.
This parameter sets BIN Speed Frequency #2 and is the frequency that is
associated with the setting of BIN Speed Reference #1 while operating in the
Speed Control mode.
See BIN Speed Reference #1 (F228) for further information on this setting.
Direct Access Number — F231
Parameter Type — Numerical
Factory Default — 80.00
Changeable During Run — Ye s
Minimum — -Max. Freq. (F011)
Maximum — Max. Freq. (F011)
Units — Hz
BIN Torque Reference Setpoint #1
Program Torque Setting  Setpoints BIN
This parameter is used to set the gain and bias of the binary input when the
discrete input terminals are used as the control input while operating in the
Torque Control mode.
This is accomplished by establishing an associated V/f output pattern for a
given binary input signal.
See BIN Speed Reference #1 for further information on this setting.
This parameter sets BIN Torque Reference Setpoint #1 and is the output
torque value that is associated with the setting of BIN Speed Reference #1
while operating in the Torque control mode.
Direct Access Number — F232
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye s
Minimum — -250.0
Maximum — 250.0
Units — %
F229 F232