Toshiba Qosmio X500

Replacement Procedures
Qosmio X500 Maintenance Manual (960-Q08) 4-iv
Figure 4-13-2 Remove the screws(from bottom side)...................................................... 4-38
Figure 4-13-3 Remove the screws(from top side) ............................................................4-39
Figure 4-13-4 Remove the Wireless Antenna and LCD cable .........................................4-39
Figure 4-13-5 Remove the hinge screws ..........................................................................4-40
Figure 4-14-1 Remove the Screws(back) .........................................................................4-42
Figure 4-14-2 Remove the screws (front) and top cover assembly .................................. 4-43
Figure 4-14-3 Disconnect the touch pad flat cable/Fingerprint cable............................... 4-44
Figure 4-15-1 Remove the touch FFC and Fingerprint cable………..………….……….4-45
Figure 4-15-2 Loose the M2.5x3 screw………………...…………………………….....4-46
Figure 4-15-3 Remove the touchpad and touchpad board……………………………....4-46
Figure 4-16-1 Remove the USB Board............................................................................ 4-48
Figure 4-17-1 Remove the B CAS Board........................................................................ 4-49
Figure 4-18-1 Disconnect the power cable......................................................................4-50
Figure 4-18-2 Remove the system board.........................................................................4-51
Figure 4-18-3 Pull away from the socket of RTC Battery...............................................4-52
Figure 4-18-4 Rotate the RTC Battery.............................................................................4-52
Figure 4-18-5 Install the RTC battery.............................................................................. 4-53
Figure 4-19-1 Remove the CPU heat sink....................................................................... 4-54
Figure 4-19-2 Remove the CPU ......................................................................................4-55
Figure 4-19-3 Apply silicon grease..................................................................................4-56
Figure 4-20-1 Remove the display mask .........................................................................4-57
Figure 4-20-2 Remove the inverter.................................................................................. 4-58
Figure 4-20-3 Remove the LCD unit............................................................................... 4-59
Figure 4-20-4 Remove the LCD hinge ............................................................................4-60
Figure 4-21-1 Remove the connector of Web Camera module.......................................4-62
Figure 4-21-2 Peel off the glue of Web Camera module................................................. 4-63
Figure 4-22-1 Removing the securing screws at left side................................................4-64
Figure 4-22-2 Removing the securing screws at right side..............................................4-65
Figure 4-22-3 Removing the Speaker Box ......................................................................4-65
Figure 4-23-1 Intel &AMD Thermal pad on North Bridge………….……………….....4-67
Figure 4-23-2 Apply silicon grease on North Bridge ......................................................4-68
Figure 4-22-3 Thermal pad position………………………………………….………....4-68