Station Apparatus
7-20
Strata CTX I&M September 2002
press 3 (Msg LED Off means that FB3 is Off)
press
4 (Msg LED Off means that FB4 is Off)
4. Press
Hold to set the option.
5. Go off-hook, then on-hook to exit the program mode.
Note
On the DKT3001, the Msg LED shows if the feature has been turned On/Off. There is no
visible indication on the other telephones. If the telephone ringer and busy tone buzzes or
doesn’t sound clear, check the country settings.
Digital Add-on Module Installation
The DADM provides 20 buttons that can be flexibly programmed for any telephone feature that is
provided by the Strata CTX system.
Install one or two DADM to a Toshiba digital telephone
(only) (shown below). The digital telephone and the
DADM must belong to the same series, i.e., 3000/3500- or
2000/2500-series
◆
See the appropriate system Installation Chapter for
loop length and secondary protection requirements.
◆
DADMs cannot be installed on telephones that have
BPCI, BVSU or DVSU installed.
◆
Only 1 ADM can be fitted to DKT3500-series.
➤
To install DADMs
See Figure 7-16 and follow these steps:
1. Loosen the four captive screws on the digital
telephone base and remove it.
2. Remove the base handset hanger.
3. Loosen two captive screws on DADM and remove bases.
4. Put the DADM supplied cable through the telephone and DADM bases.
5. Connect DADM cable connectors to P1 of DADM and P1 of DKT telephone.
6. Install base of DADM and telephone – tuck DADM cable into DADM and telephone base, as
necessary, for proper length.
7. Secure DADM to telephone base with DADM connecting plate (using four screws).
Table 7-6 Country Code Settings for Mu Law/A Law
Country FB1 FB2 FB3 FB4
USA, Canada (default is Mu Law) Off Off Off Off
Mexico Off Off Off On
Taiwan On Off Off Off
Hong Kong, Thailand Off On Off Off
Singapore, Malaysia, Indonesia, Sri Lanka, India, China On On Off On
UK, Ireland Off Off On On
Australia On Off Off On
5843
To Next Page
Loading...
