Toshiba Strara CTX Series - Chapter 1 - Strata CTX Configuration; Chapter 2 - Strata CTX100 Installation; Chapter 3 - Strata CTX670 Installation; Chapter 4 - PCB Installation

ix
Strata CTX I&M September 2002
Introduction
This manual provides detailed step-by-step instructions for installing and maintaining the Strata
CTX100 and CTX670 digital business telephone systems. It is intended for qualified service
technicians and system programmers.
Use this manual in conjunction with the Strata CTX Programming Manual which covers the programs
related to the Strata CTX100 and CTX670 systems discussed in this book.
Organisation
This manual is organised into these sections/chapters for your convenience:
◆
Chapter 1 – Strata CTX Configuration explains how to configure a Strata CTX100 or CTX670
system. It also provides worksheets for determining hardware and station equipment placement
and requirements.
◆
Chapter 2 – Strata CTX100 Installation covers site requirements and Base and Expansion
cabinet installation for the CTX100. Also includes input power requirements, cable lengths/
network requirements, and grounding requirements.
◆
Chapter 3 – Strata CTX670 Installation covers site requirements and Base and Expansion
cabinet installation for the Strata CTX670. Explains how to remove and replace cabinets on
installed systems. Also includes input power requirements, cable lengths/network requirements,
and grounding requirements.
◆
Chapter 4 – PCB Installation provides procedures for Strata CTX system Printed Circuit Boards
(PCBs) for installation into universal slots. Includes installation instructions, optional
configuration information, and wiring and programming considerations for each PCB.
◆
Chapter 5 – ISDN Interfaces contains an overview of the ISDN hardware with specific
information on the ISDN Primary Rate Interface (PRI) and Basic Rate Interfaces (BRI). It includes
instructions for installation, hardware requirements, wiring requirements, and some programming
considerations.
◆
Chapter 6 – MDF PCB Wiring contains point-to-point wiring diagrams for connection of
telephones, lines, peripheral equipment, and power supplies to the Strata CTX systems.
◆
Chapter 7 – Station Apparatus provides instructions on how to connect telephones to the Strata
CTX systems and how to configure and upgrade them for optional features. Procedures for
installing direct station selection consoles, PC and conventional attendant consoles, and door
phones also appear.