Station Apparatus
7-33
Strata CTX I&M September 2002
➤
To connect the cordless telephone using the AC adapter
1. Plug the AC adapter cord into the AC adapter input jack on the base unit (see Figure 7-29).
CAUTION!
Use only the AC adapter supplied with your cordless digital telephone.
Figure 7-29 Cordless Telephone AC Adapter
Cordless Telephone Connectors
2. Plug the AC adapter into a standard 120VAC wall
outlet.
3. Route the power cord where it is not a trip hazard,
and where it will not become chafed and create a fire
or electrical hazard.
4. Wrap the power cord around the notch on the bottom
of the base unit (see Figure 7-30).
5. Check to see that the power LED is on, indicating the
telephone has power.
6. Before using your cordless digital telephone, be sure
to raise the antenna to the vertical position.
Important!
If the cordless telephone is connected to a DKT3000/3500-series telephone, be sure to
program the DKT3000/3500 telephone to act as a DKT2000/2500; otherwise, the LCD
readouts will not fit on the cordless telephone LCD. See “DKT2000/2500 Mode On/Off”
on Page 7-17 for instructions.
Line Out
to DKT
Modular
Cords
AC Adapter
1145
5232
Line in to Digital
Telephone Circuit
(BDKU or RDSU)
See Chapter 6 –
MDF PCB Wiring
1175
Figure 7-30 Line Out Cord
To Next Page
Loading...
