Station Apparatus
7-43
Strata CTX I&M September 2002
DIP Switches
The DKT2000/2500 V.4 series telephones have DIP switches that enable use for the international
market. The DIP switches are located underneath the flexible button key strip on the DKT2000/2500
V.4 series telephones (see Figure 7-37). On the DKT2001, the DIP switch is located on the base.
S
Figure 7-37 DKT 2000/2500-series V.4 DIP Switches
Table 7-11 shows the correct country settings for the DKT2010-S, DKT2020-S, DKT2010-SD,
DKT2020-SD, DKT2001 V.4 telephones.
Note
The default DIP switch settings are preset for the USA and Canada. Therefore, you do not
need to adjust any of these from the default factory settings for North America.
Table 7-11 DKT International DIP Switch Settings (Not applicable to DKT2500-series)
Line 9
Line 8
Line 7
Line 6
Line 5
Line 4
Line 3
Line 2
Line 1
Intercom
Speed
Dial
Do Not
D
ist
u
rb
Line 17
Line 16
Line 15
Line 14
Line 13
Line 12
Line 11
Line 10
ON
1234
Fixed Buttons Microphone Location
Dial Pad
Handset
Red/Green
LED Indicators
DIP Switches
(some models)
3926
LCD Display
Flexible Buttons
USA and Canada
(Default Setting)
ON ON ON ON
Mexico ON ON ON OFF
Taiwan
OFF ON ON ON
Hong Kong
Thailand
1
ON OFF ON ON
Singapore, Malaysia, Indonesia,
Sri Lanka, India and China
OFF OFF ON OFF
ON
1
2 3 4
ON
1
2 3 4
ON
1
2 3 4
ON
1
2 3 4
5669
ON
1
2 3 4
DIP Switch PositionCountry
DIP Switch
1234
1. The DKT2000 V.4 is not compatible for Hong Kong and Thailand. Use the V.4A or
later versions in these two countries.
To Next Page
Loading...
