Toshiba Strara CTX Series - Carbon Headset;Handset Straps; Beep Strap; Microphone;Speaker Sensitivity Adjustment (Speakerphones Only)

Station Apparatus
7-41
Strata CTX I&M September 2002
➤
To adjust the volume of the HESB Loud Ringing Bell
1. Call the telephone connected to the HESB.
2. Adjust the volume control on the back of the HESB and the ring volume control on the telephone.
Note
TAPI and Simultaneous Voice and Data Upgrades (RPCI-DI or
PDIU-DI2) for 2000/2500-series Telephones is not available on the Strata CTX.
Carbon Headset/Handset Straps
If a carbon-type handset or headset is connected to the handset jack on the side of the telephone, two
jumper straps inside the telephone must be cut.
➤
To cut the straps
Note
You do not need to cut these straps if the headset is connected to the HHEU.
See Figures 7-25 and 7-35~7-36 and follow these steps:
1. Loosen the four captive screws on the telephone base, and remove the base.
2. For 2000/2500-series digital telephones, and cut the W201 and W202 carbon straps.
3. Reinstall the telephone base, and secure it with its four captive screws.
Beep Strap
A “beep” sounds whenever a dial pad or feature button is pressed on a digital telephone.
➤
To eliminate the beep sound
See Figures 7-25 and 7-35~7-36 and follow these steps:
1. Loosen the four captive screws from the telephone base and remove the base.
2. Cut the beep strap.
3. Reinstall the telephone base, and secure it with its four captive screws.
Microphone/Speaker Sensitivity Adjustment (Speakerphones
Only)
High ambient noise levels may cause the speaker on some digital telephone speakerphone models to
cut off frequently.
➤
To reduce sensitivity to loud surrounding noise
➤
Hold down Mic button, then press the Vol
▲ button. The less-sensitive level will be set after the
third flash of the Mic LED.
➤
To reset the sensitivity back to the normal level
➤
Hold down the Mic button, then press the Vol ▼ button. The normal level will be set after the
third flash of the Mic LED.
Note
On speakerphone models that are set for low sensitivity, the Mic LED flashes at the in-
use rate when the speakerphone is used. When set to normal sensitivity, the Mic LED is
on steady when using the speakerphone.