Toshiba Strara CTX Series - Step 11: Attach and Route PCB Cables

2-21
Strata CTX I&M September 2002
Strata CTX100 Installation
Step 11: Attach and Route PCB Cables
1. Determine the direction that you want the cables to exit the cabinet(s) from the following:
♦
Single Direction Cable Routing – Cabling from the Expansion Cabinet can run through the
Base Cabinet and exit from the Base Cabinet (see Figure 2-19).
Figure 2-19 Single Direction Cable Routing
♦
Opposite Direction Cable Routing – Cabling from the Expansion Cabinet can run through
the right and left sides (see Figure 2-20).
Figure 2-20 Opposite Direction Cable Routing
6006
P ower S upplyP ower S upply
AC C ord and
Battery C ables
6007
P ower S upplyP ower S upply
AC C ord and
Battery C ables