Toshiba Strara CTX Series - Tilt Stand Installation with Add-on Modules

Station Apparatus
7-23
Strata CTX I&M September 2002
Tilt Stand Installation with Add-on Modules
This section explains how to attaching a tilt stand to a digital telephone with one or two ADMs. Follow
the instructions for the appropriate number of ADMs. Use Tilt Stand models “BTSA” (not “BTSD”)
for DKTs with one or two ADMs.
➤
To attach a digital telephone with one ADM to a Tilt Stand
1. Complete the steps under “To install DADMs” on Page 7-20.
2. Make sure bottom phone jack is plugged in.
3. Remove Tilt Stand from Tilt Stand Base (see Figure 7-22).
4. Place the spacers on the outer holes, as shown (see Figure 7-23).
5. Attach Tilt Stand to bottom of DKT with screws (see Figure 7-21).
6. Reinstall the Tilt Stand Base: Fit the Tilt Stand Base over the Tilt Stand so that the “bottom pegs”
fit into the holder. Adjust Tilt Stand so that the “top pegs” fit into the top Tilt Stand Base holes (see
Figure 7-22). Do this to both stands.
7. Pull up on the Tilt Stand Bases so that they open to the maximum angle (30 degrees).
8. Push in the Release button to adjust the tilt angle (0, 10, 20 or 30 degrees) of each Tilt Stand.
Figure 7-21 Attach Tilt Stands to DKT and One ADM
5599
1 DKT
1 ADM
DKT DKT
DKT
Spacer
Spacer
2 ADM
2 ADM
1 ADM
1 ADM
2 ADM
1 ADM
2 ADM
1 ADM
2 ADM
1 ADM
2 ADM
DKT
DKT
1 ADM + 1 DKT
Put in three screws in the
positions marked “DKT.”
Insert a spacer beneath each stand as shown. Put in the
screw with the spacer first. Then insert the other two screws.
Put in three screws in the
positions marked “1ADM.”
ADM DKT