Station Apparatus
7-22
Strata CTX I&M September 2002
Tilt Stands and Wall Mounting
This section explains how to attach desktop tilt stands to 3000/3500-series or 2000/2500-series digital
DKTs or to a DSS console. Use Tilt Stand model “BTSD” (not BTSA) with a standalone DKT or DSS.
➤
To attach a Tilt Stand to a 3000/3500-series DKT or DSS
1. Plug the phone jack into the bottom of the phone or DSS console.
2. Slide the Address Tray out, then gently squeeze the tray and remove it (see Figure 7-17).
3. Pull the top of the Tilt Stand so that it’s open at an angle.
4. Slide the Tilt Stand into the former Address Tray holder. (The Stand should catch under the front
tray holder notches.) Push Stand in until it snaps into place (see Figures 7-18 and 7-19).
5. Push in the Lock Release to adjust the tilt angle (0, 10, 20 or 30 degrees, see Figure 7-20).
6. Insert the Address Tray back into its holder.
Figure 7-17 Bottom View of Digital Telephone Figure 7-18 Slide Tilt Stand into Address Tray Slot
Notice:
If you change the DKT tilt stand angle, hold the DKT
in your hand when you push the release button so the
unit does not fall onto the stand.
Figure 7-19 Tilt Stand “Snaps” In Figure 7-20 Telephone on a Tilt Stand
5448
Plug in
phone jack
Squeeze and
slide out the
address tray
5846
5847
5848
Lock Button
Release
To Next Page
Loading...
