Strata CTX I&M September 2002
3-1
Strata CTX670 Installation
3
This chapter explains how to install the Strata CTX670 system. It includes information on site
requirements and provides installation instructions for various cabinet configurations. It also explains
how to install ground wiring, AC power cabling, reserve power (Battery Backup) cabling, and Printed
Circuit Board (PCB) cabling.
Inspection
When the system is received, examine all packages carefully and note any visible damage. If any
damage is found, do not open the packages. Contact the delivery carrier immediately and make the
proper claims.
After unpacking (and before installing), check the system against the packing list and inspect all
equipment for damage. If equipment is missing or damaged, contact your supplier immediately.
Be sure to retain original packaging materials for re-use when storing or transporting system hardware.
Packaging and Storage
CAUTION!
When handling (installing, removing, examining) PCBs, do not touch the back
(soldered) side or edge connector. Always hold the PCB by its edges.
When packaging and storing the system, remove PCBs from the system cabinet (the power supply may
remain installed in the cabinet for storage and shipment). PCBs should be packaged in their original
antistatic bags for protection against electrostatic discharge. Be sure to package equipment in its
original shipping containers.
To Next Page
Loading...
