Station Apparatus
7-27
Strata CTX I&M September 2002
5. Connect the phone to the wall modular connector
with a cord approximately four inches long
(available at most telephone supply companies).
6. Route the cord into the hollow portion of the base.
7. Mount the phone on the wall mounting modular
connector plate.
➤
To wall mount DKT3001 or DKT2001 digital
SLTs
1. Loosen the screws, and remove the
telephone base.
2. Using a suitable cutter, remove the handset
hanger from the base.
3. Insert the handset hanger in the slot on the
front of the phone. The hanger fits in the
notch on the handset cradle.
4. Rotate the telephone base 180 degrees and
secure it to the telephone with its four
screws.
5. Connect the phone to the wall modular
connector with a cord approximately four
inches long (available at most telephone
supply companies).
6. Route the cord into the hollow portion of
the base.
7. Mount the phone on the wall mounting
modular connector plate.
For instructions for installing and programming the DKT2001, see “Digital Single Line Telephone
(DKT2001 only)” on Page 7-48.
Figure 7-26 Wall Mounting Base Rotation
1480
Handset
Hanger
1479
Figure 7-27 Handset
Handset Hanger
3633
Figure 7-28 Removing the Telephone Base
To Next Page
Loading...
