3 Tests and Diagnostics 3.20 ONLY ONE TEST
Subtest 7 Acceleration sensor
This subtest detects and corrects the each axis (X, Y, Z).
NOTE: Make sure that this subtest is executed on the following condition:
1. Flat desk with vertical plane to get the stability of machine.
2. The vertical wall or plane is necessary.
3. Prevent the machine from shake or shock.
Vertical plane
Flat desk
Set the machine
against the vertical plane
with the Front upward
<Example>
The figure below shows the name and position of each side.
3-46 [CONFIDENTIAL] Satellite Pro S300, TECRA A10/S10/P10 Maintenance Manual (960-684)
Right side
Left side
Back
Front
Top
(heaven surface)
To Next Page
Loading...
