Toshiba TECRA A10 - Sound Board

4 Replacement Procedures 4.26 Sound board
4.26 Sound board
Removing the Sound board
To remove the sound board follow the steps below and refer to Figure 4-51.
1. Peel off the glass tape.
2. Remove the following screws and sound board from the slot.
• M2.5×4B FLAT HEAD screw ×2
3. Disconnect the sound board FFC from the connector CN9630 on the sound board.
M2.5x4B FLAT HEAD
4-76 [CONFIDENTIAL] TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684)
Figure 4-48 Removing the sound board
Sound board
CN9630
Glass tape
Microphone
harness
Sound board FFC
M2.5x4B FLAT HEAD
CN6050