4 Replacement Procedures 4.27 Battery lock
4.27 Battery lock
Removing the Battery lock
To remove the battery lock, follow the steps below and refer to Figure 4-49.
1. Remove the battery lock button L while pushing latches inside to release them.
2. Turn up the insulator (BATT LOCK L INSULATOR) and remove the battery lock
L from the slot.
3. Remove the battery lock button R while pushing latches inside to release them.
4. Remove the battery lock R from the slot.
CAUTION: When removing the battery locks, be careful not to lose the springs.
Spring
4-78 [CONFIDENTIAL] TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684)
Figure 4-49 Removing the battery lock
Battery lock button L
Battery lock button R
Battery lock L
Battery lock R
Latch
Latch
Insulator
(BATT LOCK L INSULATOR)
Spring
To Next Page
Loading...
