Toshiba TECRA A10 - Wireless LAN Card

4.12 Wireless LAN card 4 Replacement Procedures
4.12 Wireless LAN card
Removing the Wireless LAN card
To remove the wireless LAN card, follow the steps below and refer to Figure 4-22.
1. Disconnect the wireless LAN antenna cables from the wireless LAN card (white cable
from Main and black cable from Aux) using an antenna coaxial cable disconnector.
2. Remove the following screws securing the wireless LAN card.
• M2.0×4B BIND screw ×2
3. Disconnect the wireless LAN card from the connector on the system board.
M2.0x4B BIND
Wireless LAN card
Wireless LAN antenna cable
Wireless LAN antenna cable
Figure 4-22 Removing the wireless LAN card
TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684) [CONFIDENTIAL] 4-37