Toshiba TECRA A10 - LCD Mask

4.34 LCD mask 4 Replacement Procedures
4.34 LCD mask
Removing the LCD mask
To remove the LCD mask, follow the steps below and refer to Figure 4-65 and 4-66.
1. Remove the following screws and stand the LCD mask.
CAUTION: When standing the LCD mask, hold the LCD mask with the hinge and stand
them carefully.
• M2.5×4B FLAT HEAD screw ×2
• M2.5×6C Tapping screw ×4
LCD mask
M2.5x4B FLAT HEAD
M2.5x4B FLAT HEAD
M2.5x6C Tapping
M2.5x6C Tapping
M2.5x6C Tapping
M2.5x6C Tapping
Figure 4-65 Removing the LCD mask (1)
TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684) [CONFIDENTIAL] 4-105