4.6 Fin cover 4 Replacement Procedures
4.6 Fin cover
NOTE: When repairing the PC, clean the cooling fin with a vacuum cleaner.
Do not use cotton sticks and tweezers to remove dusts. It may cause the cooling
module problem or dusts stuffed.
Removing the Fin cover
To remove the Fin cover, follow the steps below and refer to Figure 4-9.
1. Push down the hook and remove the fin cover while sliding it in the direction in the
figure below.
Hook
Fin cover
Figure 4-9 Removing the fin cover
Installing the Fin cover
To install the Fin cover, follow the steps below and refer to Figure 4-9.
1. Set the fin cover into the slot and slide it to engage the hook.
TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684) [CONFIDENTIAL] 4-21
To Next Page
Loading...
