Toshiba TECRA A10 - GFX Board;Gfx Fin

4 Replacement Procedures 4.22 GFX board/GFX fin
4.22 GFX board/GFX fin
Removing the GFX board/GFX fin
To remove the GFX board/GFX fin, follow the steps below and refer to Figure 4-39 and 4-40.
1. Remove the following screws and disconnect the GFX board (with the GFX fin)
from the connector CN5900 on the system board.
• M2.0×4B BIND screw ×2
CN5900
GFX board
GFX fin
M2.0x4B BIND
Figure 4-39 Removing the GFX board/GFX fin (1)
4-64 [CONFIDENTIAL] TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684)