4 Replacement Procedures 4.13 3G card
4-40 [CONFIDENTIAL] TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684)
Installing the 3G card
To install the 3G card, follow the steps below and refer to Figure 4-23.
1. Insert the 3G card to the connector on the system board slantwise and press it to
connect firmly.
2. Push down the 3G card and secure it with the following screws.
• M2.0×4B BIND ×2
3. Connect the 3G antenna cables to the connectors on the 3G card and arrange the
antenna cables through the slit.
To Next Page
Loading...
